|
|
|
 Replacement Parts Catalog
OEM Replacement Parts Catalog
|
What fuel injectors do you carry?
In this catalog, we carry replacement fuel injectors. This means the fuel injector is a direct fit for your stock or factory fuel injector, and is the same size physically and also the amount of fuel it supplies to your engine. If you are looking for larger fuel injectors, performance or aftermarket fuel injectors, or racing fuel injectors, then we recommend for you to check our performance catalog. When replacing injectors, we always recommend to replace the full set. The reason for this is as injectors age, they get contaminated with engine dirt, dirty fuel, etc. If you replace just one injector, then you will have one cylinder that runs more efficiently than the rest, which is not going to help the performance of your engine.
How do you replace a fuel injector, or can I get my injectors repaired or cleaned?
We do not recommend to clean or repair your fuel injectors on cars that are older than 5 years. The injector is also electrical, and we have found that sometimes there are electrical problems after having the injector cleaned and balanced. We will provide a basic how to or DIY on how to replace your injectors, but for your specific application, we recommend you ask in our car forum.
Before we begin, we recommend to de-pressurize your fuel system. Disconnect the power to your fuel pump, by either disconnecting it's power supply, or pulling the fuel pump fuse or relay. Once the fuel pump has no power, crank the engine for a few seconds. The engine might start, but should die a few seconds later. If it continues to idle, then you didn't disconnect your fuel pump.
Once the fuel system is de-pressurized, we can begin to remove various parts from the engine bay to help clear up room. On a typical system, there is a fuel feed, and fuel return. For these types of systems, you would need to disconnect both of the lines, and then disconnect the fuel pressure regulator. The fuel injectors are held in with clips that hold the harness to the injector. Remove these clips, and pop off the wiring harnesses. The fuel rail is held in with a few bolts. Remove these bolts, and then the fuel rail should be loose. Pull the fuel rail out of the intake manifold or cylinder head, and you can now easily remove the fuel injectors.
Make sure to cover the holes that are now in the intake manifold or head. Don't let any debris fall into this hole!
Pull the old fuel injectors out of the fuel rail, and then put the new injectors into the fuel rail. Make sure you have new o rings, and you are all set. Simply put everything back together, and then don't forget to plug your fuel pump back in. The car may be hard to start the first few cranks as the fuel pressure builds, and then you are all done!
Latest Isuzu Fuel Injector Applications
 |
Fuel Injector
01/98 - 07/00 Isuzu Amigo 3.2 V6 6VD1 6 per engine This injector includes 2 of 8-17113-400-0 seal and 1 of 8-17113-401-0 clip. Fuel Injector This injector includes 2 of 8-17113-400-0 seal and 1 of 8-17113-401-0 clip. |
 |
Fuel Injector
01/98 - 07/00 Isuzu Amigo 2.2 4-Cyl. X22SE Incl. seals
4 per engine This injector includes 1 each of 8-17106-005-0 and 8-25169-195-0 seals. 8-92063-104-0 clip is not included (order separately). Fuel Injector This injector includes 1 each of 8-17106-005-0 and 8-25169-195-0 seals. 8-92063-104-0 clip is not included (order separately). |
 |
Fuel Injector
98 - Isuzu Hombre 2.2 4-Cyl. 2.2 Fuel Injector OEA |
|
Fuel Injector
01/01 - 07/03 Isuzu Axiom 3.5 6VE1 6 per engine This injector includes 2 of 8-17113-400-0 seal and 1 of 8-17113-401-0 clip. Fuel Injector This injector includes 2 of 8-17113-400-0 seal and 1 of 8-17113-401-0 clip. |
 |
Fuel Injector
12/95 - Isuzu Rodeo 3.2 V6 SOHC 6VD1 Incl. clip and seals
6 per engine This injector includes 8-17112-633-0 clip and 2 of 8-17113-544-0 seal. Fuel Injector This injector includes 8-17112-633-0 clip and 2 of 8-17113-544-0 seal. |
|
Fuel Injector
07/97 - 04/03 Isuzu Rodeo 3.2 V6 4WD 6VD1 6 per engine This injector includes 2 of 8-17113-400-0 seal and 1 of 8-17113-401-0 clip. Fuel Injector This injector includes 2 of 8-17113-400-0 seal and 1 of 8-17113-401-0 clip. |
 |
Fuel Injection Corp. Fuel Injector
12/87 - 08/90 Isuzu Pickup 2.6 2WD/4WD 4ZE1 4 per engine Fuel Injector Remanufactured |
|
Fuel Injector
07/97 - Isuzu Rodeo 2.2 4-Cyl. X22,Y22 Incl. seals
4 per engine This injector includes 1 each of 8-17106-005-0 and 8-25169-195-0 seals. 8-92063-104-0 clip is not included (order separately). Fuel Injector This injector includes 1 each of 8-17106-005-0 and 8-25169-195-0 seals. 8-92063-104-0 clip is not included (order separately). |
|
Fuel Injector
09/95 - Isuzu Trooper 3.2 V6 6VD1 Incl. clip and seals
6 per engine This injector includes 8-17112-633-0 clip and 2 of 8-17113-544-0 seal. Fuel Injector This injector includes 8-17112-633-0 clip and 2 of 8-17113-544-0 seal. |
 |
Fuel Injector
08/93 - Isuzu Amigo 2.6 4ZE1 4 per engine This injector includes 8-97079-011-0 upper seal and 8-97078-989-0 cushion ring. 5-15315-005-0 lower seal is not included (order separately). Fuel Injector This injector includes 8-97079-011-0 upper seal and 8-97078-989-0 cushion ring. 5-15315-005-0 lower seal is not included (order separately). |
|
Fuel Injection Corp. Fuel Injector
07/87 - Isuzu Trooper 2.6 4-Cyl 4ZE1 4 per engine Fuel Injector Remanufactured |
|
Fuel Injection Corp. Fuel Injector
09/88 - 10/90 Isuzu Amigo 2.6 4ZE1 4 per engine Fuel Injector Remanufactured |
 |
Fuel Injector
10/91 - 08/95 Isuzu Trooper 3.2 V6 6VD1 for SOHC engine (6 per
engine; incl. clip and
seals) This injector includes 1 of 8-17111-800-0 clip and 2 of 8-17112-222-0 seal. Fuel Injector New This injector includes 1 of 8-17111-800-0 clip and 2 of 8-17112-222-0 seal. |
|
Fuel Injector
08/97 - Isuzu Trooper 3.5 V6 6VE1 6 per engine This injector includes 2 of 8-17113-400-0 seal and 1 of 8-17113-401-0 clip. Fuel Injector This injector includes 2 of 8-17113-400-0 seal and 1 of 8-17113-401-0 clip. |
|
Fuel Injector
07/97 - 04/03 Isuzu Rodeo 3.2 V6 2WD 6VD1 6 per engine This injector includes 2 of 8-17113-400-0 seal and 1 of 8-17113-401-0 clip. Fuel Injector This injector includes 2 of 8-17113-400-0 seal and 1 of 8-17113-401-0 clip. |
|
Fuel Injector
11/92 - 11/95 Isuzu Rodeo 3.2 V6 SOHC 6VD1 6 per engine; incl. clip
and seals This injector includes 1 of 8-17111-800-0 clip and 2 of 8-17112-222-0 seal. Fuel Injector New This injector includes 1 of 8-17111-800-0 clip and 2 of 8-17112-222-0 seal. |
 |
Fuel Injector
- 97 Isuzu Hombre 2.2 4-Cyl. 2.2 Fuel Injector OEA |
|
Fuel Injector
10/91 - 08/95 Isuzu Trooper 3.2 V6 6VD1 Incl. clip and seals
for DOHC engine (6 per
engine) This injector includes 8-17111-800-0 clip and 2 of 8-17112-222-0 seal. Fuel Injector This injector includes 8-17111-800-0 clip and 2 of 8-17112-222-0 seal. |
Some Isuzu Fuel Injector Applications (View Full Catalog Above)
| Isuzu Amigo 2.2 4-Cyl. |
Isuzu Amigo 2.6 |
Isuzu Amigo 3.2 V6 |
| Isuzu Axiom 3.5 |
Isuzu Hombre 2.2 4-Cyl. |
Isuzu Pickup 2.6 2WD/4WD |
| Isuzu Rodeo 2.2 4-Cyl. |
Isuzu Rodeo 3.2 V6 2WD |
Isuzu Rodeo 3.2 V6 4WD |
| Isuzu Rodeo 3.2 V6 SOHC |
Isuzu Trooper 2.6 4-Cyl |
Isuzu Trooper 3.2 V6 |
| Isuzu Trooper 3.5 V6 |
| 2.2 |
4ZE1 |
6VD1 |
6VE1 |
X22,Y22 |
X22SE |
More Applications (View Full Catalog Above)
|
|
